The application process for KISS Kapow is very simple. All you need to do is wipe it on, spread it out and then clean off any excess.
The trick in applying KISS Kapow is that a 1 gram package can coat over 1,200 square feet. To give an idea, that is the equivalent of a 32 foot yacht's hull! A little bit goes a very long way. Therefore, we recommend a short and simple exercise to learn the full potential of KISS Kapow. All you need is a window or piece of glass and a clean rag or cloth. Since KISS Kapow is completely non-toxic and invisible when applied, you can use any window in your house without worry.
The first step is to take the syringe and place the smallest dot of product on the window's surface as possible. Its best to put the dot in the center of the window as our product will spread for quite a long ways. The dot of product doesn't need to be any bigger than a pin prick. When we say KISS Kapow will spread quite a distance, we aren't exaggerating. Depending on the window, that pin prick of product may be enough to do the window's entire surface! |
Next, you will want to use your finger to spread that pin prick of KISS Kapow out as far as your can. Just keep spreading until you have a thin film spread as far out as you can with your finger. Make sure to get any excess off of your finger to spread it further! Then you will want to use your clean rag or cloth to spread the residue out further. Try and just use one corner of your rag to spread while keeping the others clear of product. Use circular motions to get the most distance. Continue to spread that residue until the glass' surface is completely clear. |
Fantastic! You have now spread KISS Kapow on and seen just how little it takes to do a large area. Now for a demonstration of how well KISS Kapow works. Take one of the corners of the rag you didn't use to spread the KISS Kapow and put on the top left corner of the window. Press down enough to feel friction but not hard enough to break the glass! Now, while pushing down, drag the rag from the top left down to the bottom right, being sure to go over where you coated the glass earlier. Phenomenal, isn't it? Now imagine the performance increase you'll see on your firearm. |
 |
Now to apply what you learned in the previous exercise to coat your firearm. We recommend having cotton swabs, Q-tips and light swatches available as well as a cleaning rod to put one of the swatches down the barrel. Its also recommended that you give your firearm a thorough cleaning before application so you are working with as clean a surface as possible. |
| First, put a few small pin-pricks worth of product along the surface of your firearm. Remember that this product will spread out so a handgun should only need 2 or 3 dollups of product on each side of the exterior and perhaps another 3 or 4 on the gun's internals. |  |
 |
Use a single cleaning swatch to wipe the KISS Kapow into every nook, cranny and bit of the firearm. Be sure to get any moving parts well coated; especially the rails of the slide or the bolt. Be sure to spread the product around and to try and get every last inch of the firearm. Remember, KISS Kapow won't work on surfaces that haven't been coated. |
| Doing the bore is the tricky part of the firearm. The swatch that you have been using throughout the cleaning of your firearm is now no doubt saturated with KISS Kapow. Take your cleaning rod and wrap the swatch through it and use it to wipe down the inside of the barrel. We recommend putting a good glob of product on the swatch to do the inside of the rifle. It doesn't need to be too big of a glob- the size of a small BB will be more than sufficient. |  |
Run the swatch through the bore numerous times to be sure you get as much of the surface as possible.
Wipe off any excess and there, your gun has been coated!